Tandberg Gatekeeper/Border Controller API D14172.01 Instrukcja Użytkownika Pobierz pdf (Strona 30)

TANDBERG Gatekeeper/Border Controller API User Guide

D14172.01 page 30 of 84

2.4.1 Command help

To get help on a specific command, type the command-type root command, followed by a command

name, followed by ? or help:

<command-type root command> <command name> ?

Example 2.12

xcommand Dial ?

xcomm dial ?

*h xCommand Dial

callSrc(r): <S: 1, 60>

callDst(r): <S: 1, 60>

Bandwidth: <1..100000000>

EncryptionMode: <Auto/On/Off>

EncryptionType: <DES/AES-128/Auto>

NOTE! Required parameters are identified by an “(r)" behind the parameter name.

2.4.2 Issuing a command

A command must start with a command-type root command, followed by a command name, followed

by a set of parameters. Parameters values can either be specified by a mark-up notation or by placing

the parameter values in the sequence specified by the help text – or a combination of these methods.

Markup notation

<command-type root command> <command> <parameter:value>

<parameter:value>...

When using this notation, the sequence in which the parameters are entered is not essential:

Example 2.13

xcommand dial Bandwidth:384 callDst:bob callSrc:alice

Abbreviations can be used for the parameter names as long as the parameter names are unique

within the command:

Example 2.14

xcommand dial B:384 callD:bob callS:alice

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 83 84

Brak uwag

Tandberg Gatekeeper/Border Controller API D14172.01 Instrukcja Użytkownika Strona 30